Sprayforming - AB 380 HSC
(Extrahard sprayformed aluminum-bronze, hardness degree 3)
Chemical composition (nom.)
- Cu Rest.
- Al 14,8 %
- Fe 4,5 %
- Mn 2,0 %
- Co 2,0 %
- Others max. 0,5 %
Mechanical properties
Yield stress (Rp N/mm2 ): > 400 N/mm2
Tensile strength (Rm N/mm2) ): > 650 N/mm2
Elongation in % A 5 : 2 %
Hardness/Brinell: 380-420 HB
Compression strength (N/mm 2) : 1466 N/mm2
(All values = Nominal values)
Machineability: 65 /100 (Index, Free cutting brass CuZn39Pb3 = 100 /100)
Mating material: Min. surface hardness >500 HB Rec. Surface roughness < 1 Ra.
Information
- Previous alloy-name by LM was WAB-2 (change of alloy name year 2004, due to slight change in chemical composition).
- The great benefit with the alloy and the castingmethod of Sprayforming is that it creates a tensionfree, fully homogenous material that is easier to machine and friendlier towards the machining tools (up to 40 % saving costs of tools due to good chipping).
- 25 % extended lifespan of products due to higher pressure resistance, good homogeneity
Areas of use
Same areas of use as AB 340/380 and AB 340 HSC, however, more resistant alloy with a higher degree of abrasion-resistance and extended lifespan on produced parts. Used for example in bending- and wiping-blocks and pressing in stainless steels, deep-drawing of seamless tubes and specially alloyed steel sheets etc.
Other material information
| Physical properties | Value |
| Density, g/cm 3 | 7,0 |
| Modulus of elasticity KN/mm 2 | 120.0 |
| Thermal conductivity W / m · K | 35 |
| Welding, brazing and soldering | Abilities |
| Arc-welding | Not recommended |
| Brazing / Soldering | Not recommended |
| Polishing, mechanical | Good |
| Polishing, electrolytical | Not recommended |
| Shapes and forms available | Available as |
| Continously casted mtrl. (tubes,round solids, flats) | X |
| Cast material (die- or sand-cast) | |
| Forged material | |
| Partly or fully machined parts | X |
| Welding equipment (welding-wire / welding-rods) |









